TYRE GLOSS |
Infosafe™ No. | VARD5 | Issue Date | February 2017 | Status | ISSUED by MILESTON | BS: 1.17.117 |
Classified as hazardous according to criteria of NOHSC
1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER | |
Product Name | TYRE GLOSS |
Company Name | Milestone Chemicals Pty. Ltd. (ABN 85115166357) |
Address | 115 Northern Road West Heidelberg VIC 3081 |
Emergency Tel. | (03) 9450 4555 Mon-Fri 8am - 6pm |
Telephone/Fax Number | Tel: (03) 9450 4555 Fax: (03) 9457 5518 |
Recommended Use | Used as a gloss enhancer and rejuvenator for tyres and all rubber and vinyl trims on all types of vehicles. |
Other Names | None Listed |
2. HAZARDS IDENTIFICATION | |
Hazard Classification | Aspiration Hazard: Category 1 Eye Damage/Irritation: Category 2A Skin Corrosion/Irritation: Category 2 |
Risk Phrase(s) | R65 Harmful: may cause lung damage if swallowed. |
Safety Phrase(s) | S16 Keep away from sources of ignition - No smoking. S25 Avoid contact with eyes. S26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S62 If swallowed, do not induce vomiting; seek medical advice immediately and show this container or label. |
3. COMPOSITION/INFORMATION ON INGREDIENTS | |
Chemical Characterization | Liquid |
Ingredients | Name | CAS | Proportion | Hazard Statement(s) | ||
Polydimethylsiloxane | 63148-62-9 | 10-30 % | ||||
Petroleum hydrocarbon solvent | 60-100 % | |||||
Other ingredients determined not to be hazardous | N/A | <10% | ||||
4. FIRST AID MEASURES | |
First Aid Measures | M |
Inhalation | Remove from exposure, rest and keep warm. Apply artificial respiration if breathing has stopped. Unless exposure has been slight obtain medical attention. |
Ingestion | If swallowed, do NOT induce vomiting. Give a glass of water to be taken slowly. Obtain medical attention. |
Skin | If skin contact occurs, remove contaminated clothing and wash skin thoroughly. Wash clothing before re-use. If irritation persists obtain medical attention. |
Eye | If in eyes, hold eyes open, flood with water for at least 15 minutes and see a doctor. |
First Aid Facilities | Eye wash station and normal washroom facilities. |
Advice to Doctor | Product is a petroleum spirit mixture. Vomiting has not been induced because of risk of aspiration into the lungs. If swallowed, may cause gastrointestinal irritation, nausea, vomiting and cramping. Possible CNS depression. Possible delayed onset of chemical pneumonitis. Contact Poisons Information Centre. |
Other Information | M |
5. FIRE FIGHTING MEASURES | |
Suitable Extinguishing Media | Foam, dry powder or vaporising liquids. |
Hazards from Combustion Products | Decomposes on heating emitting oxides of carbon. |
Specific Methods | Fire fighters to wear self-contained breathing apparatus if risk of exposure to products of decomposition. If safe to do so, remove containers from path of fire. |
Specific Hazards | This material is a combustible liquid. |
Precautions in connection with Fire | M |
Unsuitable Extinguishing Media | M |
6. ACCIDENTAL RELEASE MEASURES | |
Emergency Procedures | M |
Spills & Disposal | Material may be slippery when spilt. Walk cautiously. Ventilate area. Wear protective equipment to prevent skin and eye contact, as outlined under personal protection in this MSDS. Bund area using sand or soil - to prevent run off into drains and waterways. Use absorbent (soil, sand, vermiculite or other inert material). Collect and seal in properly labelled containers for disposal. |
7. HANDLING AND STORAGE | |
Precautions for Safe Handling | M |
Conditions for Safe Storage | Store in a cool place and out of direct sunlight. Store away from sources of heat or ignition. Store away from oxidizing agents. Keep containers closed, when not using the product. Store in original packages as approved by manufacturer. |
Storage Regulations | M |
8. EXPOSURE CONTROLS/PERSONAL PROTECTION | |
Biological Limit Values | M |
Other Exposure Information | TLV-TWA: None assigned, suggested level 200 ppm, 800 mg/m3 [Manufacturer] TLV-STEL: None assigned. |
Engineering Controls | Use only flame proof equipment. Ensure adequate ventilation. In most circumstances natural ventilation systems are adequate unless the material is heated, reacted or otherwise changed in some type of chemical reaction, then the use of a local exhaust ventilation system is recommended. |
Respiratory Protection | M |
Eye Protection | M |
Hand Protection | M |
Personal Protective Equipment | Avoid contact with the skin and eyes. Avoid breathing the vapour. Personal protection to be selected from those recommended below, as appropriate to mode of use, quantity handled and degree of hazard:- Goggles or safety glasses Gloves, PVC Always maintain a high level of personal hygiene when using this product. That is wash hands before eating, drinking, smoking or using the toilet. |
9. PHYSICAL AND CHEMICAL PROPERTIES | |
Form | Liquid |
Appearance | Clear thin purple liquid |
Odour | Mild kerosene like odour |
Decomposition Temperature | M |
Melting Point | M |
Boiling Point | Greater than 100C |
Solubility in Water | Insoluble in water |
Specific Gravity | 0.82 |
pH Value | Not Applicable |
Vapour Pressure | M |
Evaporation Rate | M |
Odour Threshold | M |
Viscosity | M |
Octanol/Water Partition Coefficient | M |
Density | M |
Flash Point | >90C |
Flammability | Combustible liquid, flash point >90C. |
Auto-Ignition Temperature | M |
Flammable Limits - Lower | M |
Flammable Limits - Upper | M |
Kinematic Viscosity | M |
Dynamic Viscosity | M |
Explosion Limit - Upper | M |
Explosion Limit - Lower | M |
Other Information | Will react with oxidising agents. Contact with strong oxidising agents may cause fire. Slippery when spilled |
10. STABILITY AND REACTIVITY | |
Chemical Stability | Stable under normal use conditons. |
Conditions to Avoid | Heat, flames, ignition sources and incompatibles. |
Incompatible Materials | Strong alkalis, acids, oxidizing agents. |
Hazardous Decomposition Products | Emits smoke and fumes when heated to decomposition. |
Hazardous Reactions | M |
Hazardous Polymerization | M |
11. TOXICOLOGICAL INFORMATION | |
Toxicology Information | No adverse health effects are expected, if the product is handled in accordance with this Material Safety Data Sheet and the product label. Symptoms and effects that may arise if the product is mishandled and overexposure occurs are: |
Inhalation | May cause irritation to the nose, throat and respiratory system with effects including: Dizziness, headache and loss of co-ordination. |
Ingestion | Harmful if swallowed. Vomiting, may cause this product to be aspirated into the lungs, which may lead to chemical pneumonitis. |
Skin | May cause irritation to the skin, with effects including; Redness and itchiness. |
Eye | May cause irritation to the eyes, with effects including: tearing, pain, stinging and blurred vision. |
Chronic Effects | Prolonged or repeated exposure or deliberately concentrating and inhaling the vapour(s) may result in lung function incapacity or death. |
12. ECOLOGICAL INFORMATION | |
Ecotoxicity | In large concentrations this product is detrimental to the aquatic environment. |
Persistence / Degradability | Substance generally evaporates leaving a silicon oil. |
Mobility | Water will carry this substance rather than dilute it. |
Environment Protection | Prevent spillages from entering drains, natural waters or the environment. |
13. DISPOSAL CONSIDERATIONS | |
Disposal Considerations | M |
Waste Disposal | Refer to appropriate authority in your State. Dispose of material through a licensed waste contractor. Normally suitable for disposal by approved waste disposal agent. |
14. TRANSPORT INFORMATION | |
Transport Information | Where this material is stored, handled and used below its flashpoint it is not classified as a Dangerous Good according to the Australian Code for the Transport of Dangerous Goods by Road and Rail. However, the material is classified as a Class C1 Combustible Liquid according to AS1940. |
IMDG Marine Pollutant (MP) | M |
15. REGULATORY INFORMATION | |
Regulatory Information | HAZARDOUS SUBSTANCE. SCHEDULED POISON. Classified as Hazardous according to criteria of National Occupational Health & Safety Commission, Australia (NOHSC). Classified as a Scheduled Poison according to the Standard for the Uniform Scheduling of Medicines and Poisons (SUSMP). |
Poisons Schedule | S5 |
Hazard Category | Harmful |
AICS (Australia) | All components listed. |
16. OTHER INFORMATION | |
Date of preparation or last revision of MSDS | 18/02/2017 |
Literature References | Preparation of Safety Data Sheets for hazardous Chemicals Code of Practice Standard for the Uniform Scheduling of Medicines and Poisons Australian Code for the Transport of Dangerous Goods by Road & Rail Globally Harmonised System of classification and labelling of chemicals |
Signature of Preparer/Data Service | Technical manager Tel: (03) 9450 4555 |
Technical Contact Numbers | Emergency Advice All Hours: Chief Chemist Tel: (03) 9450 4555 Mon-Fri 8am - 6pm Poisons Information Centre: 13 11 26 - 24hrs |
Other Information | This SDS summarises at the date of issue our best knowledge of the health and safety hazard information of the product, and in particular how to safely handle and use the product in the Workplace. Please refer to the technical datasheet (Instructions for use), and the label on the drum. The company cannot anticipate or control the individual working conditions encountered and so each user should read this SDS carefully, and if in doubt ring the Contact Point Number given below. |
End of MSDS | |
(C) Copyright Chemical Safety International Pty Ltd | ||
Copyright in the source code of the HTML, PDF, XML, XFO and any other electronic files rendered by an Infosafe system for Infosafe MSDS displayed is the intellectual property of Chemical Safety International Pty Ltd. Copyright in the layout, presentation and appearance of each Infosafe MSDS displayed is the intellectual property of Chemical Safety International Pty Ltd. The compilation of MSDS's displayed is the intellectual property of Chemical Safety International Pty Ltd. Copying of any MSDS displayed is permitted for personal use only and otherwise is not permitted. In particular the MSDS's displayed cannot be copied for the purpose of sale or licence or for inclusion as part of a collection of MSDS without the express written consent of Chemical Safety International Pty Ltd. | ||
|